A one-component ultraviolet (UV) curing adhesive has the advantages of convenient use, fast curing speed, high light transmittance, high bonding strength and the like. Suitable for PVC bonding.
JTX-6161 is a one-component ultraviolet (UV) curing adhesive, which has the advantages of convenient use, fast curing speed, high light transmittance and high bonding strength. Suitable for PVC bonding.
1. Performance parameters:
| Exterior color | Colorless or slightly yellow transparent liquid |
| Viscosity (mpa.s) 25℃ | 300～800 |
| Deep curing time (glue thickness 1.5-2.0mm) | 30 to 60 seconds |
| Positioning time (glue thickness <0.1mm) | 6 to 15 seconds |
| Curing energy (mj/cm2) | 1500 |
| Bond strength (MPa) | ≥10 |
| Hardness (Shore D) | 40～50 |
2. Construction method
1. Clean the surface of the material to be adhered. If there is any residual detergent after cleaning, it needs to be completely dried before applying glue.
2. Apply an appropriate amount of UV glue on the surface of the material to be bonded, then close it with another material to be bonded, and discharge possible air bubbles, so that the UV glue is evenly distributed, and ensure that the bonding parts are covered with UV glue (ideal thickness of the glue layer < 0.1mm), and finally fix the position.
3. Use a cloth or paper towel to wipe off the excess glue overflowing around the sticky material (do not use water, alcohol, acetone and other solvents for scrubbing). Do not let the glue contact UV light before this step.
4. The two bonded materials need to be irradiated by a UV lamp with a certain light intensity to fully cure the UV glue on the bonding surface (the irradiation time depends on the type, power, irradiation distance and light transmittance of the bonding material, etc.).
5. After UV lamp irradiation and curing, if there is still glue overflowing around the adhered material, it can be scraped off with a blade.
3. Precautions for use
1. At least one of the materials to be adhered is transparent.
2. The grease, moisture, impurities and flatness on the surface of the material to be bonded will directly affect the bonding quality. Be sure to wipe it dry and clean to ensure that the bonding surface is flat.
3. During the bonding process, be sure to discharge possible air bubbles; during the light curing process, ensure that the adhered parts can be irradiated by the UV lamp. Before positioning the material to be adhered, do not move it under the UV lamp, so as to avoid whitening and affect the appearance.
4. UV glue is an industrial chemical. Before the glue is cured by light, please take precautions to avoid direct skin contact; if you accidentally drop the skin, please wipe it with alcohol; if you are allergic to the skin, please seek medical attention immediately.
4. Packaging
50g/piece, 250g/piece, 1kg/piece
5. Storage
Store in a cool, ventilated and sealed condition away from light, away from heat and sunlight. The ideal storage temperature is 5~30℃, and the shelf life is not less than 6 months.